说明：
测量32件产品的平整度并在测试前做好标记.
按包装标准包装
模拟正常（实际）运输条件往返三次.
测试完成后,再测一次平整度!比较测试前和测试后平整度的变化.
注意：
32件产品必须放在盒子里并分成三部分（盒子的上面、中间和下面）,三部分的数量分别是10件、10件和12件.
为模拟正常运输+一次退货（换货）的行程,所以要往返三次.
英语翻译
英语翻译
Spec.:
1.Measure 32 pcs products flatness and marked before testing
2.According to the packing standard packaging
3.Simulation of normal delivery conditions go back and forth run three times
4.when we finished the testing and measure the flatness again Comparison the flatness variation status before and after testing
Notes :
1.32 pcs products must place into the BOX and divided into 3 parts ( upper- middle -lower of the box )
and the quantity are 10 pcs - 10 pcs - 12 pcs
2.In order to simulate normal delivery + 1 times returned goods ( exchange goods) journey
so need to go back and forth run three times
Spec.:
1.Measure 32 pcs products flatness and marked before testing
2.According to the packing standard packaging
3.Simulation of normal delivery conditions go back and forth run three times
4.when we finished the testing and measure the flatness again Comparison the flatness variation status before and after testing
Notes :
1.32 pcs products must place into the BOX and divided into 3 parts ( upper- middle -lower of the box )
and the quantity are 10 pcs - 10 pcs - 12 pcs
2.In order to simulate normal delivery + 1 times returned goods ( exchange goods) journey
so need to go back and forth run three times
英语人气：377 ℃时间：2020-03-29 22:00:28
优质解答
我来回答
类似推荐